AQUALUMA Underwater Lighting 3 series was designed with long life in mind. The corrosion proof, injection molded polycarbonate housing that is the signature of all the AQUALUMA range was first created for the 3 series.
Available in a range of 3 colours, Blue, Green or White, all are supplied with sealant, 3.7 metres of cable, carry a two year warranty and if necessary can be serviced from inside the boat.
Make your boating experience all that more illuminating and install an AQUALUMA Underwater Light today.
NOTE:3 Series Specifications
•No Lens seal to leak.
•Very low DC power consumption. Approx. 0.6 of an amp per light @ 12 volts or 0.3 of an amp @ 24 volts.
•Very low heat emission.
•Meets World EMI standard
•Can be operated out of the water.
•Long life, high output LED light engine.
•High tech patented polymer housing.
•No bonding to anodes required. (Housing cannot corrode)
•Light engine will accept 12 or 24 volt DC power source.
•Reverse polarity protected
•Serviceable an upgradable from inside the boat.
•Each Light comes with 3.7 metres (13 feet) of cable.
•Easy and low cost installation
•Recommended for boast up to 50ft
•60mm thru hull fitting
•Standard 12 deg or Wide angle 12 x 50 deg elipitcal optics
•Australian designed and manufactured
•Color temperature 9000 to 10000 degrees Kelvin (the colder the white the further it travels in water)
•Lux output 8850
•Color temperature 470nm (the color that travels further in salt water than any other)
•Lux output 11,750
•Color temperature 510nm (great color in fresh water)
•Lux output 10,750